Oil seal used for front crankshaft oil seal on V7 Sport and gearbox seal on Convert

 1 in stock

90402838-z 90402838 GU90402838 90 40 28 38
 9040 2838 9040.2838 90.40.28.38

Woodruff key for oil pump shaft

 This part is due back in stock soon, call 01484 841395 to reserve yours

 13148300 GU13148300 13 14 83 00
 1314 8300 1314.8300 13.14.83.00

Complete oil pump

 This part is available by special order, request a quote

12146400-z 12146400 GU12146400 12 14 64 00
 1214 6400 1214.6400 12.14.64.00

Factory upgraded oil pump with 16mm wide teeth as fitted to later big twins. Gives increased flow and can be retro fitted to earlier 850/1000 models which originally had 14mm teeth pumps

 This part is available by special order, request a quote

 30146400 GU30146400 30 14 64 00
 3014 6400 3014.6400 30.14.64.00

Oil pressure sender, M12 thread, male bullet connector

Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 More than 5 in stock

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Oil pressure switch M12 thread, male spade connector

Superceded by ELA19670 . See ENA12640 for replacement crush washer if required

 Sorry, this part is no longer available.

 12768700 GU12768700 12 76 87 00
 1276 8700 1276.8700 12.76.87.00

Length of pipe used for oil return and breather applications depending on model

Also known as Guzzi ref. 12157600. This pipe has an outside diameter slightly larger than the original so will not fit through the hose support bracket on some models

 1 in stock

 95985136 GU95985136 95 98 51 36
 9598 5136 9598.5136 95.98.51.36

Cartridge oil filter UFI 23 149 00

Fits Daytona 1000 models where filter screws into base of sump. This is an 8 sided UFI filter.
Use tool TOA41006 if your filter is located inside the sump, use tool TOA01201 if you change your oil filter without removing the sump.

You may also require SIA10070 which is the crush washer for the drain plug and ENA14036 (sump gasket). Please note that Daytona RS and T5 Polizia use filter SIA15300

 More than 5 in stock

 14153000 GU14153000 14 15 30 00
 1415 3000 1415.3000 14.15.30.00

8 sided oil filter tool for new UFI filters

This tool is for models where the sump needs to be removed to get to the oil filter. This fits SIA14530 and the later metal finish filter SIA15300 which was updated to 8 sides in late 2018. Not suitable for Mahle oil filters

 This part is due back in stock soon, call 01484 841395 to reserve yours

Gasket for mesh filter

 5 in stock

 12153200 GU12153200 12 15 32 00
 1215 3200 1215.3200 12.15.32.00